Power Cords; Laser Safety - Compaq Armada e500 - Notebook PC Quick Reference Manual

Power Cords

If you were not provided with a power cord for your computer or
for an AC power accessory intended for use with your computer,
you should purchase a power cord that is approved for use in your
country.
The power cord must be rated for the product and for the voltage
and current marked on the product's electrical ratings label. The
voltage and current rating of the cord should be greater than the
voltage and current rating marked on the product. In addition, the
diameter of the wire must be a minimum of 0.75 mm²/18AWG,
and the length of the cord must be between 5 feet (1.5 m) and
6½ feet (2 m). If you have questions about the type of power cord
to use, contact your Compaq authorized service provider.
A power cord should be routed so that it is not likely to be walked
on or pinched by items placed upon it or against it. Particular
attention should be paid to the plug, electrical outlet, and the point
where the cord exits from the product.

Laser Safety

All Compaq systems equipped with laser products comply with
appropriate safety standards, including IEC 825. With specific
regard to the laser, the equipment complies with laser product
performance standards set by government agencies for Class 1
laser products. It does not emit hazardous light; the beam is totally
enclosed during all modes of customer operation and maintenance.
CDRH Regulations
The Center for Devices and Radiological Health (CDRH) of the
U.S. Food and Drug Administration implemented regulations for
laser products on August 2, 1976. These regulations apply to laser
products manufactured from August 1, 1976. Compliance is
mandatory for products marketed in the United States.
WARNING:
!
procedures other than those specified herein or in the laser product
installation guide may result in hazardous radiation exposure.
B-6 Regulatory Notices
Use of controls or adjustments or performance of