Compaq t1000 - Terminal Thin Client PC Manual page 58

Factory default: Input
This option specifies the type of flow control used by the line port to communicate readi-
ness to transmit or receive data from the host.
None - No flow control
Input - XON/XOFF on received data
Output - XON/XOFF on transmitted data
In/Out - XON/XOFF on transmitted & received data
Hardware - DTR/CTS hardware flow control.
Factory default: 8
This option specifies the number of data bits sent for each transmitted character.
Factory default: 1
This specifies the number of stop bits sent for each transmitted character.
Factory default: Unlimited
The setting of this option determines the maximum effective baud rate that the emulator
transmits terminal reports and data sent as a result of pasting data to the host.
Factory default: Selected
When this option is selected, normal two-way communication between the emulator and
the host is enabled. When unselected, the emulator is in Local mode and data is not sent to,
or received from the host. Data typed on the keyboard displays on the screen or associated
with an action if a control command is typed.
Factory default: Unselected
The setting of this option determines whether keyboard entered characters are displayed
on the screen as well as sent to the host. When unselected, characters are not displayed
when they are transmitted unless the host 'echoes' them back.
Setup Menus