Compaq t1000 - Terminal Thin Client PC Manual page 54

Factory default: Selected
This option applies to all emulations and determines what happens when the cursor is
moved beyond the last line of the current page. When selected, the displayed data scrolls
up and the cursor remains on the last line. When unselected, the cursor moves to the top of
the same page.
Factory default: Unselected
This option applies to the WY-50+, WY-60 and all the TVI emulations. It determines
what happens when the cursor reaches the top or bottom of the page.
When unselected, the cursor either moves to the top of the same page or data scrolls up
from the bottom, as determined by the setting of the Auto Scroll option. When selected, a
new page of memory is displayed.
Factory default: Unselected
This option applies to the WY-50+ and WY-60 emulations and determines what effect an
ASCII DEL character has on displayed characters. The other emulations ignore the DEL
character.
When unselected, the DEL character is ignored. When selected, the DEL character is
interpreted as a destructive backspace, causing the character to the left of the cursor to be
deleted and the cursor to move into that position.
Factory default: Unselected
This option applies to all emulations and specifies whether or not an audible warning
sounds when the cursor reaches a specified column. The default bell column number is 72
in 80-column mode and 124 in 132-column mode.
Factory default: Selected
When this option is selected, the emulator recognizes an additional set of Wyse codes that
are not normally supported by specific non-Wyse terminals.
Setup Menus