Compaq t1000 - Terminal Thin Client PC Manual page 49

The IBM 3270 emulation provides compatibility with software designed to drive the IBM
3270 terminal. Note that the initial display is an ASCII text screen known as Network Vir-
tual Terminal mode (NVT mode for short). The setting of the IBM Model option in this
dialog box determines the size of the display and whether or not extended attributes are
supported. Refer to the IBM 3270 Emulation chapter for details.
The IBM 5250 emulation provides compatibility with software designed to drive IBM
5250 type alphanumeric terminals. This emulation can be used for connection to an IBM
AS/400, System/36 or System/38. Note that the initial display is an ASCII text screen
known as Network Virtual Terminal mode (NVT mode for short). Refer to the IBM 5250
Emulation chapter for details.
SCO Console is an emulation of the SCO UNIX box.
The TVI 910+, TVI 920 and TVI 925 emulations provide compatibility with software
designed to drive the TeleVideo 910+, 920 and 925 terminals, respectively, as emulated by
the Wyse WY-50/50+/60 terminals. Refer to the Wyse Emulations chapter for details.
The VT52 and VT100 emulations enable you to run applications written for the DEC
VT52 and VT100 terminals, respectively. Refer to the DEC VT Emulations chapter for
details.
The VT400 7-Bit and VT400 8-Bit emulations enable you to run applications written for
the DEC VT320 terminal, the difference is in their treatment of 8-bit control codes. When
VT400 7-Bit is selected, all 8-bit codes are converted to their 7-bit equivalents, whereas
VT400 8-Bit leaves 8-bit codes unchanged. If you are using VT200 applications, select
VT400 7-Bit. Refer to the DEC VT Emulations chapter for details.
The WY50, WY50+ and WY60 emulations provide compatibility with software designed
to drive the Wyse WY-50, WY-50+ and WY-60 terminals, respectively. Refer to the Wyse
Emulations chapter for information on these emulations.
This option is not supported.
This option enables you to specify the nationality of the keyboard being used. It is impor-
tant that this is correct, otherwise the characters displayed may not match the key legends.
Factory default: VT420
This option identifies the terminal model being emulated in response to a terminal identifi-
cation request from the host. You can either select from the list of IDs or you can edit the
text box and enter a different terminal identity.
Setup Menus