Remove the four Phillips PM2.5×4.0 screws (2) that secure the system board to the base enclosure.
6.
Loosen the captive Phillips PM2.5×14.0 screw (3) that secures the video heat sink and system board
7.
to the base enclosure.
Use the optical drive connector (1) to lift the right side of the system board (2) until it rests at an
8.
angle.
Remove the system board (3) by pulling it away from the base enclosure at an angle.
9.
Reverse this procedure to install the system board.
Component replacement procedures
79
Need help?
Do you have a question about the Pavilion HDX9000 - Entertainment Notebook PC and is the answer not in the manual?