Lift the right side of the WLAN module compartment cover (2), swing the cover up and to the left,
and remove the cover. The WLAN module compartment cover is included in the Plastics Kit, spare
part number 448171-001.
Disconnect the WLAN antenna cables (1) from the WLAN module.
connected to the WLAN module "Main" terminal. The white WLAN antenna cable (labeled with the
number 2 or with a white band) is connected to the WLAN module "Aux" terminal. Computer models
equipped with an 802.11a/b/g/n WLAN module will have an additional wireless antenna
cable (2) (labeled with the number 3 or with a yellow band). Disconnect this cable.
Remove the two Phillips PM2.5×5.0 screws (3) that secure the WLAN module to the system board.
(The edge of the module opposite the slot rises away from the computer.)
Remove the WLAN module (4) by pulling it away from the slot at an angle.
WLAN module slot.
Reverse this procedure to install a WLAN module.
Chapter 4 Removal and replacement procedures
The main WLAN antenna cable (labeled with the number 1 or with a black band) is
WLAN modules are designed with a notch (5) to prevent incorrect installation into the