Remove the battery (see
4.
Remove the following components:
5.
Hard drive (see
a.
Optical drive (see
b.
Keyboard (see
c.
Hinge cover (see
d.
Rear cover (see
e.
Top cover (see
f.
Subwoofer (see
g.
Remove the video connector board:
Disconnect the video connector board cable (1) from the system board.
1.
Remove the Phillips PM2.5×4.0 screw (2) that secures the video connector board to the base
2.
enclosure.
Route the video connector board cable under the processor heat sink pipe (3).
3.
Remove the video connector board (4) from the base enclosure.
4.
Reverse this procedure to install the video connector board.
74
Chapter 4 Removal and replacement procedures
Battery on page
38).
Hard drive on page
45)
Optical drive on page
Keyboard on page
54)
Hinge cover on page
Rear cover on page
57)
Top cover on page
59)
Subwoofer on page
72)
52)
56)