Removing the HP PC Blade Enclosure from the Rack
WARNING!
prevent the enclosure from falling and causing bodily harm when removing it from the rack.
To remove the HP PC Blade Enclosure from the rack:
1.
Power down each HP Blade PC
2.
Power down the enclosure
3.
Disconnect all cables and power cords from the AC power source.
4.
Disconnect all cables and power cords from the enclosure rear panel.
5.
Remove all HP Blade PCs and HP Blade PC blank bezels
Bezel on page
6.
Remove both hot-plug power supplies
7.
Remove the interconnect tray
8.
Loosen the thumbscrews on the front of the enclosure (1).
9.
Remove the enclosure from the rack (2).
Figure 3-10
NOTE:
damages the thumbscrews.
Reverse the previous steps to install the enclosure into the rack.
16
Chapter 3 Removal and Replacement Procedures
Rack rails do not have safety latches. Be sure that at least two persons are available to
(Powering Down the Enclosure on page
14).
(Removing the Interconnect Tray on page
Removing the enclosure from the rack
Pull the enclosure out using the handles. Pulling the enclosure by the thumbscrews
(Powering Down a Blade PC on page
(Hot-Plug Power Supplies on page
12).
10).
(Removing an HP Blade PC Blank
8).
15).