Hot-Plug Power Supplies - HP BladeSystem bc2800 - Blade PC Reference Manual

Hot-Plug Power Supplies

WARNING!
other power supply may be used. Attempting to use a different power supply in the HP PC blade
Enclosure G2, or attempting to use the DPS-1200KB power supply in a different enclosure, may
result in damage to your equipment. The DPS-1200KB power supply ships with a bright yellow label
attached for easy identification.
CAUTION:
power supply is available.
NOTE: You can use the Integrated Administrator to identify a failed power supply. Refer to the HP
Integrated Administrator User Guide for details.
To remove a redundant hot-plug power supply:
1. Disconnect the power cord from the AC power source.
2. Disconnect the power cord from the hot-plug power supply.
3. Press the port-colored release button and open the hot-plug power supply handle (1).
4. Pull the hot-plug power supply out of the enclosure (2).
Figure 3-1
Reverse the previous steps to replace the hot-plug power supply.
8 Chapter 3 Removal and Replacement Procedures
The DPS-1200KB power supply must be used in the HP PC Blade Enclosure G2. No
To avoid a thermal event, do not remove a failed power supply until a replacement
Removing a hot-plug power supply