Fan Backplane Assembly - HP BladeSystem bc2800 - Blade PC Reference Manual

16. Remove the fan cage from the enclosure (7).
Figure 3-12
Reverse the previous steps to replace the fan cage.

Fan Backplane Assembly

To remove the fan backplane assembly:
1. Power down each HP Blade PC
2. Power down the enclosure
3. Disconnect all cables and power cords from the AC power source.
4. Disconnect all cables and power cords from the enclosure rear panel.
5. Remove all HP Blade PCs
CAUTION:
bays, not to HP Blade PCs. If HP Blade PCs change locations within the enclosure, Integrated
Administrator settings must also be adjusted to ensure accurate security. Refer to the HP
Integrated Administrator User Guide for more information on security settings.
6. Remove both hot-plug power supplies
7. Remove the interconnect tray
8. Remove the enclosure from the rack
on page
9. Place the enclosure on a level, non-conductive surface.
10. Open the access door
11. Disconnect the fan cable from the power backplane.
12. Remove the fan cage
Removing the fan cage from the enclosure
(Powering Down the Enclosure on page
(Removing a Blade PC on page
Integrated Administrator security settings are assigned to HP PC Blade Enclosure
(Removing the Interconnect Tray on page
16).
(Opening the Access Door on page
(Fan Cage on page
(Powering Down a Blade PC on page
(Hot-Plug Power Supplies on page
(Removing the HP PC Blade Enclosure from the Rack
18).
12).
10).
13).
8).
15).
17).
Non-Hot-Plug Procedures 19