Removing And Replacing The Enclosure - HP D3600 Maintenance And Service Manual

16. Replace the fan modules. See
17. Replace the I/O module cables. See
18. Replace the power cables.
19. Apply power to the enclosure and confirm the system is powered on. See
operating status of the disk enclosures" (page 13)
20. Confirm that the system is operating normally. See
enclosures" (page 13)

Removing and replacing the enclosure

The operation is performed after Support determines that the enclosure is the source of the issue
and requests the enclosure be replaced
WARNING!
1. Unplug the power cables.
2. Remove I/O cables. See
3. Label drives for removal.
4. Remove the drives. See
5. Remove power supplies See
6. Remove the I/O modules. See
7. Remove both fan modules. See
8. Loosen the captive CTO screws behind the latch on the front left and right bezel ears of the
chassis (1)
9. Loosen the rear CTO hold-down bracket.
10. Slide the enclosure out of the rails (2) and set it on a secure surface.
WARNING!
is being loaded into the rack above chest level, a third person must assist with aligning the
enclosure with the rails while the other two people support the weight of the enclosure.
11. Slide in the new enclosure and tighten the retaining screws.
12. Re-attach the rear CTO hold-down bracket.
13. Replace the I/O modules. See
14. Replace the power supplies. See
15. Replace the fan modules. See
16. Replace the hard drives and/or SSDs. See
17. Replace I/O module cables. See
22 Removal and replacement procedures
"Removing and replacing the fan module" (page 19)
Check to make sure data on the drives is backed up. Back up the data if required.
"Removing and replacing I/O Cables" (page 17)
"Removing a drive" (page 16)
"Removing and replacing a power supply" (page 18)
"Removing and replacing the I/O module" (page 18)
Always use at least two people to lift an enclosure into the rack. If the enclosure
"Removing and replacing the I/O module" (page 18)
"Removing and replacing the fan module" (page 19)
"Removing and replacing the I/O module" (page 18)
"Verifying the operating status of the disk
"Removing and replacing the fan module" (page 19)
"Removing and replacing a power supply" (page 18)
"Replacing a drive" (page 16)
"Removing and replacing the I/O module" (page 18)
"Verifying the