HP BladeSystem bc2800 - Blade PC Reference Manual page 52

POST Error Messages
Code/Message
1800-Temperature Alert
1998-Master Boot Record
Backup has been lost. Press
any key to enter Setup to
update the MBR Backup.
Invalid Electronic Serial
Number
6817-System was rebooted
due to a potential lock-up
6901-System was gracefully
shut down due to CPU
overheating.
6904–System experienced an
unexpected shutdown on
previous boot.
6906–Embedded Network
Controller B Hardware Failure
Detected
6907-Embedded Network
Controller A Hardware Failure
Detected
6908-System Board Hardware
Failure Detected
6909-System Board Graphics
Subsystem Failure Detected
46 Chapter 6 POST Error Messages
Health LED Possible Cause
Amber Internal temperature
exceeds specification.
Amber The previously saved
copy of the MBR has
been corrupted.
Amber Electronic serial
number has been lost.
Amber System image or
software issue.
Green Internal temperature
exceeds specification.
Green Forced enclosure
shutdown or improper
diagnostic adaptor
insertion
Red NIC B has failed.
Red NIC A has failed.
Red System Board has
failed.
Red System board
graphics have failed.
Recommended Action
●
Ensure that the system fans are functioning
properly and that the enclosure has
adequate ventilation.
●
Check the processor heatsink.
●
Replace the blade PC.
Run Computer Setup to update the MBR
backup.
●
Run Computer Setup. If data is loaded/will
not allow changes, download SP5572.EXE
(SNZERO.EXE) from http://www.hp.com.
●
Run Computer Setup, enter serial number
under Security, System ID, then save
changes.
●
Check event logs in the operating system
to ensure you do not have a software
lockup.
●
Disable Automated System Recovery in
F10 Setup.
●
Follow standard operating system
debugging procedure.
●
Reinstall the system image.
●
Ensure that the system fans are functioning
properly and that the enclosure has
adequate ventilation.
●
Check the processor heatsink.
●
Replace the blade PC.
If the problem persists, replace the blade PC.
●
Clear CMOS.
●
Replace the blade PC.
●
Clear CMOS.
●
Replace the blade PC.
●
Clear CMOS.
●
Replace the blade PC.
●
Clear CMOS
●
Replace the blade PC.