Removing the Interconnect Tray
To remove the interconnect tray:
1.
Power down each HP Blade PC
2.
Power down the enclosure
3.
Disconnect all cables and power cords from the AC power source.
4.
Disconnect all cables and power cords from the enclosure rear panel.
5.
Remove both hot-plug power supplies
6.
Push the locking latches toward the front of the enclosure to expose the release latches securing
the interconnect tray in the enclosure (1).
7.
Pull the release latches toward the rear of the enclosure (2).
8.
Remove the interconnect tray from the enclosure (3).
Figure 3-9
NOTE:
Perform step 6 simultaneously in both power supply bays.
Reverse the previous steps to replace the interconnect tray.
NOTE:
When installing the interconnect tray, be sure that the release latches are in the open
position. When closing the release latches on the interconnect tray, be sure that the locking latches
click audibly into place.
(Powering Down a Blade PC on page
(Powering Down the Enclosure on page
Removing the interconnect tray from the enclosure
(Hot-Plug Power Supplies on page
Preparing for Non-Hot-Plug Procedures
12).
10).
8).
15