Command Line Interface - HP BladeSystem bc2800 - Blade PC Reference Manual

3. Select the bay from the bay list.
4. Click Remote Console.
The Remote Console screen appears.
5. Click Remote Console.
A new window opens that enables you to connect to the blade PC terminal interface.
6. If the blade PC is running the operating system:
a. Return to the Web-based user interface and click Virtual Buttons in the left panel.
CAUTION:
a blade PC.
b. If the blade PC is off, select Power On at the bottom of the screen; otherwise, select
Reboot at the bottom of the screen.
c. Click Apply and return to the remote console session.
7. When prompted to press
8. To exit Computer Setup from the file menu:
a. Select one of the following:
◦
◦
◦
b. To close the remote console session:
9. When prompted to press F10, press
a. Press
b. Press D.

Command Line Interface

To access the Computer Setup (F10) Utility of a blade PC using the command line interface:
1. If the blade PC is running the operating system, reboot the blade PC by typing the following
commands sequentially:
REBOOT BAY <bay number>
Yes
2. Connect to the blade PC by observing its bay number and typing:
CONNECT BAY <bay number>
3. When prompted to press
Without the blade PC health driver, the Integrated Administrator cannot reboot
F10 for the Computer Setup (F10) Utility, press
Apply Defaults and Exit
Ignore Changes and Exit
Save Changes and Exit
Ctrl_ (control underscore).
F10 for the Computer Setup (F10) Utility, press
Esc then 0 (zero) to confirm.
Esc then 0.
Esc then 0.
Remote Troubleshooting 65