Cf_P-Mane Command; Cf_P-Manetime Command; Cf_On-Sta Command; Cf_Standbymode Command - Sanyo PLC-WK2500 - 2500 Lumens Manual

PLC-WK2500 Expand Serial Command Functional Specifications

8.10.11 CF_P-MANE Command

Command "CF_Pÿ MANE_%1"[CR]
"OFF" --------------------------------- Set Power Management to OFF
"READY" ----------------------------- Set Power Management to Ready
%1 "SHUTDOWN" --------------------- Set Power Management to Shut Down mode
"UP" ----------------------- The same operation as pressing Up key or Left key
"DN" ----------------------- The same operation as pressing Down key or Right key
Set/Cancel Power Management
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.12 CF_P-MANETIME Command

Command "CF_P-MANETIME_%1"[CR]
"01" ~ "30" ----------------------- Directly select setting time by the minute
"UP" ------------------------------- Plus one minute (01 → 02 → ÿ e ÿ e ÿ e → 30 → 01)
ÿ ÿ
"DN" ------------------------------- Minus one minute(30 → 29 → ÿ e ÿ e ÿ e → 01 → 30)
Set Power Management time
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.13 CF_ON-STA Command

Command "CF_ONÿ STA_%1"[CR]
"ON" -------------------------- Set Direct on active
"OFF" ------------------------- Set Direct on inactive
%1
"UP" ----------------------- The same operation as pressing Up key or Left key
"DN" ----------------------- The same operation as pressing Down key or Right key
Set/Cancel Direct On Start
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.14 CF_STANDBYMODE Command

Command "CF_STANDBYMODE_%1"[CR]
"ECO" ---------------------- Less standby electricity
%1
"NORMAL" ------- -------- Normal standby electricity
Switch Standby Mode setting.
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
42 / 74