Cf_Hdmi Sound Command; Cf_Terminal Command; Cf_Standbymode Command; Cf_P-Mane Command - Sanyo PLC-WL2503 - 2500 Lumens Manual

PLC-WL2500 / WL2501/ WL2503 Expand Serial Command Functional Specifications

8.10.13 CF_HDMI SOUND Command

Command "CF_HDMI SOUND_%1"[CR]
"HDMI" ----------------------- Select PCM sound (Digital sound)
%1
"EXTERNAL" ------------- Select External sound input
Select sound mode of HDMI setup.
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.14 CF_TERMINAL Command

Command "CF_TERMINAL_%1"[CR]
"COMPUTER" ----------------Set Input mode
%1
"MONITOR" ------------------- Set Monitor Out mode
Set Terminal setup. This command is available in normal Power ON status.
Details
Terminal means Computer 2 in this model.
Acceptable
Response
Unacceptable

8.10.15 CF_STANDBYMODE Command

Command "CF_STANDBYMODE_%1"[CR]
"ECO" ---------------------- Less standby electricity
%1
"NORMAL" --------------- Normal standby electricity
Switch Standby Mode setting.
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.16 CF_P-MANE Command

Command "CF_Pÿ MANE_%1"[CR]
"OFF" --------------------------------- Set Power Management to OFF
"READY" ----------------------------- Set Power Management to Ready
"SHUTDOWN" --------------------- Set Power Management to Shut Down mode
%1 "UP" ------------------------------ Switch Power management setting
"DN" ------------------------------ Switch Power management setting
Set/Cancel Power Management
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
When Input is Computer 2, the projector returns "101" and the
command is not executed.
"000"[CR]
"Error Code"[CR]
(Off → Ready → Shutdown → Off)
(Off → Shutdown → Ready → Off)
"000"[CR]
"Error Code"[CR]
38/72