PLC-XC50/55 Expand Serial Command Functional Specifications
8.10.10 CF_REAR Command
Command
"CF_REAR_%1"[CR]
"ON" --------------------------- Set Rear to ON
%1
"OFF" ------------------------- Set Rear to OFF
Set/Cancel Rear setting.
When Rear is ON, image is left/right reversed.
Details
The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.10.11
CF_STANDBYMODE Command
Command
"CF_STANDBYMODE_%1"[CR]
"ECO" ---------------------- Less standby electricity
%1
"NORMAL" ------- -------- Normal standby electricity
Switch Standby Mode setting.
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.10.12
CF_P – MANE Command
Command
"CF_Pÿ MANE_%1"[CR]
"OFF" --------------------------------- Set Power Management to OFF
"READY" ----------------------------- Set Power Management to Ready
"SHUTDOWN" --------------------- Set Power Management to Shut Down mode
"UP" ------------------------------ Switch Power management setting
%1
"DN" ------------------------------ Switch Power management setting
Set/Cancel Power Management
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.10.13
CF_P – MANETIME Command
Command
"CF_P-MANETIME_%1"[CR]
"01" ~ "30" ----------------------- Directly set Powermenagement timer by minute
ÿ ÿ
"UP" ------------------------------- Plus one minute (01 – 2...30 – 01...)
"DN" ------------------------------- Minus one minute ( 30-- 29 --..01 –30...)
Set Power Management time
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
ÿ Off --Ready --Shutdown --Offÿ
ÿ Off --Shutdown --Ready-- Offÿ
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
36/67