PLC-XD2200/2600
Expand Serial Command Functional Specifications
8.10.14 CF_P-MANE Command
Command
"CF_Pÿ MANE_%1"[CR]
"OFF" --------------------------------- Set Power Management to OFF
"READY" ----------------------------- Set Power Management to Ready
"SHUTDOWN" --------------------- Set Power Management to Shut Down mode
%1
"UP" ------------------------------ Switch Power management setting
"DN" ------------------------------ Switch Power management setting
Set/Cancel Power Management
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.10.15 CF_P-MANETIME Command
Command
"CF_P-MANETIME_%1"[CR]
"01" ~ "30" ----------------------- Directly select setting time by the minute
"UP" ------------------------------- Plus one minute (01 → 02 → ÿ e ÿ e ÿ e → 30 → 01)
ÿ ÿ
"DN" ------------------------------- Minus one minute(30 → 29 → ÿ e ÿ e ÿ e → 01 → 30)
Set Power Management time
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.10.16 CF_ON-STA Command
Command
"CF_ONÿ STA_%1"[CR]
"ON" -------------------------- Set Direct on active
"OFF" ------------------------- Set Direct on inactive
"UP" -------------------------- Switch setting (On → Off → On → ÿ e ÿ e ÿ e )
%1
"DN" --------------------------- Switch setting (On → Off → On → ÿ e ÿ e ÿ e )
Note) "UP" and "DN" behave the same.
Set/Cancel Direct On Start
The status set by this command is stored in EEPROM and its setting is effective
Details
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
(Off → Ready → Shutdown → Off)
(Off → Shutdown → Ready → Off)
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
38 / 71