Cf_Keystone Command; Cf_Kystnmode Command; Cf_Ceil Command; Cf_Rear Command - Sanyo PLC-WK2500 - 2500 Lumens Manual

PLC-WK2500 Expand Serial Command Functional Specifications
8.7.7

CF_KEYSTONE Command

Command "CF_KEYSTONE_%1"[CR]
"UP" ------------- Correct Keystone distortion to reduce upper part of image
"FUP" ----------- Correct Keystone distortion to reduce upper part by 2steps
%1 "DN" ------------- Correct Keystone distortion to reduce lower part of image
"FDN" ----------- Correct Keystone distortion to reduce lower part by 2steps
"RST" ------------ Reset Keystone
Change Keystone distortion correction
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.7.8

CF_KYSTNMODE Command

Command "CF_KYSTNMODE_%1"[CR]
"STR" --------- Set Keystone store mode to Store
%1
"RST" --------- Set Keystone store mode to Reset
Set Keystone store mode
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.7.9

CF_CEIL Command

Command "CF_CEIL_%1"[CR]
"ON" ------------------------ Set Ceiling to ON
%1
"OFF" ----------------------- Set Ceiling to OFF
Set/Cancel Ceiling setting.
The value set by this command is stored in EEPROM and its setting is effective
Details
even after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.7.10

CF_REAR Command

Command "CF_REAR_%1"[CR]
"ON" --------------------------- Set Rear to ON
%1
"OFF" ------------------------- Set Rear to OFF
Set/Cancel Rear setting.
When Rear is ON, image is left/right reversed.
Details The status set by this command is stored in EEPROM and its setting is effective
after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"201"[CR] ----When reaching the Keystone correction limit or
reaching 1 step to correction limit and "FDN"/"FUP"
is received.
(The command is not executed)
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
33 / 74