Cf_Vscale Command; Cf_Vpos Command - Sanyo PLC-WK2500 - 2500 Lumens Manual

PLC-WK2500 Expand Serial Command Functional Specifications
8.7.3

CF_VSCALE Command

Command "CF_VSCALE_%1"[CR]
"032" --------- +32
"031" --------- +31
ÿ
"002" --------- +2
"001" --------- +1
"000" --------- +0
%1 "-01" ---------- -1
"-02" ---------- -2
ÿ
"-31" ---------- -31
"-32" ---------- -32
"UP" ---------- Vertical Scale setting value + 1
"DN" ---------- Vertical Scale setting value - 1
Set Vertical Scale
This command is available in normal Power ON status.
Note1) When Screen setting is not in Custom mode, projector changes image
Details
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not execute.
Acceptable
Response
Unacceptable
8.7.4

CF_VPOS Command

Command "CF_VPOS_%1"[CR]
"015" --------- +15
"014" --------- +14
ÿ
"002" --------- +2
"001" --------- +1
"000" --------- +0
%1 "-01" ---------- -1
"-02" ---------- -2
ÿ
"-14" ---------- -14
"-15" ---------- -15
"UP" ---------- Vertical Position setting value + 1
"DN" ---------- Vertical Position setting value – 1
Set Vertical Position
This command is available in normal Power ON status.
Details Note1) When Screen setting is not in Custom mode, projector changes image
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not execute..
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
31 / 74