Configuring the SNMP Access Control List
These settings include:
To set up a list of hosts that are authorized to access the printer using SNMP:
1.
Launch your web browser.
2.
Enter your printer's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3.
Click Properties.
4.
Select the Protocol folder on the left navigation panel.
5.
Select SNMP.
6.
If prompted, enter your Admin or Key User name and password.
7.
Enter up to ten host IP addresses in the SNMP Access Control List field. Separate entries
with a blank or a comma, specify ranges with a hypen (-), and use an asterisk (*) to
represent a group of numbers (e.g., 13.62.156.*).
8.
Click the Save Changes button.
See also:
About Access Control Lists
Disabling SNMP
If you are not using SNMP, disable it to prevent unauthorized access through applications that
use these protocols. If you disable SNMP, the following driver features are also disabled:
■
PrintingScout alerts
■
Walk-Up Printing Installer
■
Smart Trays
■
PhaserSMART
■
Auto supplies ordering
■
Consumable levels
■
Warning and error status
■
Synchronization with installed options, such as hard drive, memory, and extra trays
To disable SNMP:
1.
Launch your web browser.
2.
Enter your printer's IP address in the browser's Address field (http://xxx.xxx.xxx.xxx).
3.
Click Properties.
4.
Select the Protocols folder on the left navigation panel.
5.
Select SNMP.
6.
If prompted, enter your Admin or Key User name and password.
7.
Click the Disable SNMP Now button.
8.
Click the Save Changes button.
on page 4-4
System Administrator Guide
4-20
Configuring SNMP