Fax Defaults; Fax Configuration - Xerox 8560MFP - Phaser Color Solid Ink Administrator's Manual
System administrator guide
Hide thumbs
Also See for 8560MFP - Phaser Color Solid Ink:
- Service documentation (296 pages) ,
- User manual (281 pages) ,
- Evaluator manual (20 pages)
Table of Contents
Advertisement
Fax Defaults
View, set, or change general system fax settings from the Fax Defaults page. Making changes
to system default settings through CentreWare IS is the same as making the corresponding
changes from the system control panel. When you are satisfied with your selections, click
Save Changes to keep the settings or click Discard Changes to keep the previous settings.
Note:
For additional information, see the User Guide on the Software and Documentation
CD
ROM.
-
Fax Configuration
Select settings for the following options to configure the fax function:
Country: Select your Country from the drop-down list. All available countries for the system
are displayed in the list. Regions 1-8 in the country list are provided to allow for future support
of additional countries. The default setting is None.
Note:
When the Country setting is changed, Dial Type, Redial Count, Redial Time Interval,
Dial Pause, and Dial Delay are set to their default settings.
Line ID: Enter the fax telephone number in this field. Line ID can be up to 20 characters in
length.
Line Name: Enter the Line Name in this field. Line Name can be up to 30 characters in length.
Dial Type: Select the Dial Type setting from the drop-down list. The default setting is Tone.
■
Pulse: The telephone line uses Pulse dialing.
■
Tone: The telephone line uses Tone dialing.
Line Monitor Volume: Select the audio Line Monitor Volume setting from the drop-down
list. The default setting is 2/Med.
■
0/Off: Turns the audio line monitor volume Off.
■
1/Low: Sets the audio line monitor volume to Low.
■
2/Med: Sets the audio line monitor volume to Medium.
■
3/High: Sets the audio line monitor volume to High.
Auto Activity Report: This setting turns On or Off automatic printing of an activity report
after every 50 faxes or errors. The default setting is On. If Auto Activity Report is set to On, an
activity report is printed after 50 of any of the following occur:
■
Faxes transmitted.
■
Faxes received.
■
Errors during fax transmission or reception.
Starting Rate: This setting specifies the initial fax transmission and reception rate. The
default settings are 33.6 kbps (Super G3) for the Phaser 8560MFP system, system. The
following values are supported:
■
4800 bps
■
9600 bps
System Administrator Guide
6-2
Fax Defaults
Advertisement
Table of Contents
