Cable Lengths; System Connections - Xerox 4050 Installation Planning Manual

Cable lengths

XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODELS 4050/4090 NPS
7.
This chapter provides cable requirements for your 4050/4090 NPS
system. To ensure all of your cable requirements are met, it is
important to work with your Xerox representative.
Cable lengths are important considerations in planning your layout,
as components can be separated only up to the length of the data
interface cables that connect them.
Cables supplied with the printer are of sufficient length to meet the
needs of most installations. Some of these cables are specific
lengths to conform to engineering and safety standards.
Data cables The printer components can be separated up to the length of the data
interface cables that connect them. The printer and controller are
connected by a 25-foot / 7.5 meter data cable.
Power cables The 4050/4090 power cable lengths are as follows:
Table 7-1.
Power cable
Printer controller
Printer
Warning: Using an inappropriate alternate cable may degrade the
!
performance of your equipment and may also be hazardous.
Note: Cable length loss must be factored in if equipment is installed
in a raised-floor environment. You should also consider that part of
the length of a cable is routed inside the equipment to connect with
interior power or data receptacles.

7System connections

Power cable lengths
Length
8 feet / 2.4 meters
10 feet / 3 meters
Ä
7-1