Using the turning radius table
XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODELS 4050/4090 NPS
Figure 6-9.
T-shaped turn
1
Passage A
2
Passage B
Figure 6-10. L-shaped turn
1
Passage A
2
Passage B
To use the following table:
1. Measure the minimum width of the passage or doorway you
need to use. This is Passage A.
2. Find that number (or the next higher number) in the turning
radius table and read across to the corresponding minimum
value for Passage B, depending on the type of turn the
equipment must negotiate.
PRINTER SPECIFICATIONS AND REQUIREMENTS
6-15