Xerox 4050 Installation Planning Manual page 49

Sun Ultra 60 workstation placement
XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODELS 4050/4090 NPS
CONTROLLER SPECIFICATIONS AND REQUIREMENTS
Following are guidelines for placement of the Sun Ultra 60
workstation components of the printer controller.
Figure 5-3. Sun Ultra 60 printer controller hardware
1 Mouse and mouse pad
2 Keyboard
3 Monitor
4 Processor
5 Table
To ensure consistent performance and avoid any damage to
equipment, follow these rules for placing the components of the Sun
Ultra 60 controller.
Do:
•
Place the monitor and processor on a desk or table top,
separate from the printer. The monitor should be placed beside
the processor, on the same surface. (The cartridge tape drive
may be placed on top of the processor.)
•
Keep the processor in an upright, vertical position as illustrated
below.
•
Allow at least 6 inches / 152 mm of unobstructed space at the
front and rear of the processor, so the fan and vents are not
blocked.
5-5