Environmental Specifications; Space Requirements; Printer Controller Placement - Xerox 4050 Installation Planning Manual

Environmental specifications

Space requirements

Printer controller placement

XEROX DOCUPRINT NETWORK PRINTER SERIES INSTALLATION PLANNING GUIDE FOR MODELS 4050/4090 NPS
The environmental requirements for the NPS printer controller are all
satisfied by the printer module. Refer to the "Printer specifications
and requirements" chapter of this guide.
For recommended environmental ranges for the printer work area,
refer to the "Printer specifications and requirements" chapter of this
guide.
Table 5-3. Heat dissipation specifications for the 4050/4090
NPS controller
Heat dissipation
Processor
Monitor
This section provides recommendations for placement of printer
controller hardware components.
For printer component space requirements, refer to the "Printer
specifications and requirements" chapter of this guide. Contact your
service representative if you have questions not specifically
addressed in this guide.
You should consider the following factors when deciding where to
place the DocuPrint printer controller:
•
Adequate work space and service clearance around the
equipment
•
Proximity to electrical and network connectors
•
Security of the work area. You may need to place the system in
an area where you can restrict access to it.
You must supply a table or desk as a work surface for the printer
controller. The top of the table must provide at least 36 by 36 inches
/ 91 by 91 cm of space for each component, to allow enough space
for the components and cables, as well as for service access.
Refer to the "Printer controller specifications and requirements"
summary table at the end of this chapter to make sure the tables you
supply can support the weight of the printer controller hardware
elements, and that they are suitable for the intended use.
Warning: The printer controller must be positioned within the line-
!
of-sight of the printer for safety purposes while servicing the
equipment.
!
CONTROLLER SPECIFICATIONS AND REQUIREMENTS
1,100 BTU per hour
408 BTU per hour
5-3