Cisco VGD-1T3 Software Configuration Manual page 191

Using the Setup Script
cisco Systems, Inc.
Cisco IOS Software, vgd Software (VGD-JS-M), Experimental Version 12.4(20080516:192539)
[vgd 1t3_pi9_051608 107]
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Fri 16-May-08 16:24 by wykwan
ROM: System Bootstrap, Version 12.4(22r)T, RELEASE SOFTWARE (fc1)
vgd 1t3 uptime is 3 hours, 11 minutes
System returned to ROM by reload at 10:20:57 UTC Mon May 19 2008
System image file is "tftp://223.255.254.254/wykwan/vgd-js-mz"
Cisco VGD (BCM) processor (revision 0x21) with 393215K/131072K bytes of memory.
Processor board ID JAE09148V9A
SB-1 CPU at 750MHz, Implementation 1025, Rev 0.3, 256KB L2 Cache
Last reset from IOS reload
Manufacture Cookie Info:
EEPROM Version 0x4, Board ID 0x603,
Board Hardware Version 2.6, Item Number 800-6572289-01,
Board Revision C0, Serial Number JAE09148V9A.
Processor 0x0, MAC Address 0013.803e.8b44
2 Gigabit Ethernet interfaces
78 Serial interfaces
28 Channelized/Clear T1/PRI ports
1 Channelized T3 port
4 DSPs, 64 Voice resources
512K bytes of NVRAM.
125184K bytes of ATA External CompactFlash (Read/Write)
Configuration register is 0x0
Press RETURN to get started!
When the following message appears, enter yes to continue:
Step 2
Would you like to enter the initial configuration dialog? [yes/no]: yes
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Step 3 When the following message appears, enter no to configure all interfaces. Note that if you enter yes, your
system will not be configured correctly:
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: no
Step 4 When the following message appears, enter yes to see the current interface summary:
First, would you like to see the current interface summary? [yes]: yes
Any interface listed with OK? value "NO" does not have a valid configuration
Interface
GigabitEthernet0/0
GigabitEthernet0/1
170 West Tasman Drive
San Jose, California 95134-1706
IP-Address
unassigned
unassigned
OK? Method Status
NO unset up
NO unset up
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
Getting Started
Protocol
up
down
181