Cisco VGD-1T3 Software Configuration Manual page 140

Configuring MGCP Gateway Support
•
•
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
dial-peer voice tag pots
Example:
Router(config)# dial-peer voice 101 pots
Step 4
service mgcpapp
Example:
Router(config-dial-peer)# service mgcpapp
Step 5
direct-inward-dial
Example:
Router(config-dial-peer)# direct-inward-dial
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
130
Do not use the destination-pattern or session target dial-peer configuration commands or the
connection voice-port configuration command on the MGCP gateway, unless you are configuring
MGCP gateway fallback. To configure MGCP gateway fallback, you must configure the H.323 dial
peers with the destination-pattern and session target dial-peer configuration commands.
Do not use the application mgcpapp command in dial peers that support PRI backhaul or BRI
backhaul.
enable
configure terminal
dial-peer voice tag pots
service mgcpapp
direct-inward-dial
port port/slot/DS1 port number:group
exit
Using Cisco Unified Communications Manager to Configure MGCP Gateway Support
Purpose
Enables privileged EXEC mode.
Enter your password when prompted.
•
Enters global configuration mode.
Designates the specified dial peer as a POTS device and
enters dial-peer configuration mode.
Enables MGCP on the dial peer.
Note Do not use this command in dial peers that support
PRI backhaul or BRI backhaul.
(Optional) Enables the direct inward dialing (DID) call
treatment for an incoming called number.
Required for T1 PRI dial peers.
•