Configuring The Voice Feature Card; Examples - Cisco VGD-1T3 Software Configuration Manual

Configuring the Voice Feature Card

Configuring the Voice Feature Card

A voice feature card with one to six PVDM2-64 modules supports different port densities depending on
codec complexity.
The voice feature card should work without specific modifications to the software configuration on these
platforms. However, you might need to upgrade the firmware on the voice feature card, depending on
the software release you are using.
To upgrade the firmware of the voice feature card, follow these steps:
Command or Action
Step 1
Router> enable
Step 2
Router# configure terminal
Step 3
Router(config)# voice dsp slot [/dsp] [slot
[/dsp]]
Step 4
Router(config-voice-dsp)# firmware location
flash:filename
Step 5
Router(config-voice-dsp)# end
Step 6
Router(config-voice-dsp)# Ctrl-Z
Router#

Examples

An example of output from the the show voice dsp version command follows. This output verifies the
firmware upgrade.
Router# show voice dsp version
IOS-Bundled Default
==========================
system:/bundled_fw_image
On-Flash Dspware-Filename
=========================
flash:90110.rbf
flash:rel90107.rbf
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
58
Basic Configuration Using the Command-Line Interface on the Cisco VGD 1T3 Voice Gateway
Purpose
Enters privileged EXEC mode.
Enters global configuration mode. You are in
global configuration mode when the prompt
changes to
Enters voice dsp config mode and specifies the
slot/DSP location or a range of slots/DSPs.
•
•
•
•
Specifies that the firmware is in flash memory and
identifies the file name.
Exits config-voicedsp mode and returns to global
configuration mode.
Returns to privileged EXEC mode.
Version Firmware-Type
======= =============
23.6.0 c5510
Version Firmware-Type
======= =============
9.0.110x c5510
9.0.107x c5510
.
Router(config)#
For the slot argument, specify a value from 1
to 7 to specify the location of the VFC.
For the dsp argument, specify a value from 1
to 24 to specify the location of the DSP.
To specify a range, the first two arguments
specify the first slot/DSP in the range. The
second two arguments specify the last
slot/DSP in the range.
Where slash marks appear in the command
syntax, they are required.