Cisco VGD-1T3 Software Configuration Manual page 183

Using Cisco Unified Communications Manager to Configure RSVP Agent
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
DETAILED STEPS
show sccp
Step 1
Before the start of a call, use the show sccp command to verify that the MTP or transcoder device is
successfully registered with Cisco Unified Communications Manager:
Router# show sccp
SCCP Admin State: UP
Gateway IP Address: 192.168.20.1, Port Number: 0
IP Precedence: 5
User Masked Codec list: None
Call Manager: 192.168.20.11, Port Number: 2000
Call Manager: 192.168.20.12, Port Number: 2000
Call Manager: 192.168.20.13, Port Number: 2000
.
.
.
Software MTP Oper State: ACTIVE - Cause Code: NONE
Active Call Manager: 192.168.20.12, Port Number: 2000
TCP Link Status: CONNECTED, Profile Identifier: 10
Reported Max Streams: 1004, Reported Max OOS Streams: 0
Supported Codec: pass-thru, Maximum Packetization Period: N/A
Supported Codec: g711ulaw, Maximum Packetization Period: 30
Supported Codec: rfc2833 dtmf, Maximum Packetization Period: 30
RSVP : ENABLED
Step 2 show sccp connections
During the call, use the show sccp connections command to display information about the active SCCP
connections established for the call, the DSP farm service type (MTP or transcoding), codec (for
example, pass-through or g711ulaw), and remote end information:
Router# show sccp connections
sess_id
17537646
17537646
show sccp
show sccp connections
show sccp connections details
show sccp connections rsvp
show ip rsvp installed
show sccp statistics
debug sccp all
debug call rsvp-sync [events | func-trace]
debug voip ccapi inout
Priority: N/A, Version: 5.0.1, Identifier: 3
Priority: N/A, Version: 5.0.1, Identifier: 1
Priority: N/A, Version: 5.0.1, Identifier: 2
conn_id stype mode
19438263 mtp
19438260 mtp
codec ripaddr
sendrecv pass_th 192.168.20.5
sendrecv pass_th 192.168.22.1
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
Enabling the RSVP Agent on the Voice Gateway
rport sport
35548 16576
16832 19164
173