Where To Go Next - Cisco VGD-1T3 Software Configuration Manual

Using the Setup Script
%LINK-3-UPDOWN: Interface Serial1, changed state to down
<Additional messages omitted.>
When the messages stop appearing on your screen, press Enter to access the following prompt:
Step 2
Router>
%AT-6-ONLYROUTER: Ethernet0: AppleTalk port enabled; no neighbors found
Note
The
Step 3
completed the basic gateway configuration. However, this is not a complete configuration. At this point
you have two options:
•

Where to Go Next

At this point you can go to the section
the gateway manually.
CCDE, CCENT, Cisco Eos, Cisco Lumin, Cisco Nexus, Cisco StadiumVision, Cisco TelePresence, the Cisco logo, DCE, and Welcome to the
Human Network are trademarks; Changing the Way We Work, Live, Play, and Learn and Cisco Store are service marks; and Access Registrar,
Aironet, AsyncOS, Bringing the Meeting To You, Catalyst, CCDA, CCDP, CCIE, CCIP, CCNA, CCNP, CCSP, CCVP, Cisco, the Cisco Certified
Internetwork Expert logo, Cisco IOS, Cisco Press, Cisco Systems, Cisco Systems Capital, the Cisco Systems logo, Cisco Unity, Collaboration
Without Limitation, EtherFast, EtherSwitch, Event Center, Fast Step, Follow Me Browsing, FormShare, GigaDrive, HomeLink, Internet Quotient,
IOS, iPhone, iQ Expertise, the iQ logo, iQ Net Readiness Scorecard, iQuick Study, IronPort, the IronPort logo, LightStream, Linksys, MediaTone,
MeetingPlace, MeetingPlace Chime Sound, MGX, Networkers, Networking Academy, Network Registrar, PCNow, PIX, PowerPanels, ProConnect,
ScriptShare, SenderBase, SMARTnet, Spectrum Expert, StackWise, The Fastest Way to Increase Your Internet Quotient, TransPath, WebEx, and
the WebEx logo are registered trademarks of Cisco Systems, Inc. and/or its affiliates in the United States and certain other countries.
All other trademarks mentioned in this document or Website are the property of their respective owners. The use of the word partner does not imply
a partnership relationship between Cisco and any other company. (0807R)
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and
figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and
coincidental.
© 2008 Cisco Systems, Inc. All rights reserved.
If you see this message, it means that no other routers were found on the network attached to the
port.
prompt indicates that you are now at the command-line interface (CLI) and you have just
Router>
Run the setup script in the System Configuration dialog again and create another configuration.
Enter the following commands to repeat the setup script:
Router> enable
Password: password
Router# setup
"Verifying Basic Setup," for step-by-step instructions to configure
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
Where to Go Next
185