Cisco VGD-1T3 Software Configuration Manual page 44

Analyzing the System Boot Dialog
00:01:10: %TRUNK_CLOCK-6-SWITCH: Switching to the clock on slot 2 port 7 priority 205
as the current primary has gone bad
00:01:10: %TRUNK_CLOCK-6-BAD_CLOCKS: There are no good clocks in the system. Remain in
HOLDOVER mode
00:01:10: %TRUNK_CLOCK-6-BAD_CLOCKS: There are no good clocks in the system. Remain in
HOLDOVER mode
00:01:10: %TRUNK_CLOCK-6-BAD_CLOCKS: There are no good clocks in the system. Remain in
HOLDOVER mode
00:01:10: %TRUNK_CLOCK-6-BAD_CLOCKS: There are no good clocks in the system. Remain in
HOLDOVER mode
00:01:10: %TRUNK_CLOCK-6-BAD_CLOCKS: There are no good clocks in the system. Remain in
HOLDOVER mode
5. Enter the show version command to check the system hardware, Cisco IOS image name, uptime,
and restart reason:
Router# show version
Cisco IOS Software, vgd Software (VGD-JS-M), Experimental Version
12.4(20080516:192539) [router_pi9_051608 107]
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Fri 16-May-08 16:24 by wykwan
ROM: System Bootstrap, Version 12.4(22r)T, RELEASE SOFTWARE (fc1)
router uptime is 3 hours, 11 minutes
System returned to ROM by reload at 10:20:57 UTC Mon May 19 2008
System image file is "vgd-js-mz"
Cisco VGD (BCM) processor (revision 0x21) with 393215K/131072K bytes of memory.
Processor board ID JAE09148V9A
SB-1 CPU at 750MHz, Implementation 1025, Rev 0.3, 256KB L2 Cache
Last reset from IOS reload
Manufacture Cookie Info:
EEPROM Version 0x4, Board ID 0x603,
Board Hardware Version 2.6, Item Number 800-6572289-01,
Board Revision C0, Serial Number JAE09148V9A.
Processor 0x0, MAC Address 0013.803e.8b44
2 Gigabit Ethernet interfaces
78 Serial interfaces
28 Channelized/Clear T1/PRI ports
1 Channelized T3 port
4 DSPs, 64 Voice resources
512K bytes of NVRAM.
125184K bytes of ATA External CompactFlash (Read/Write)
Configuration register is 0x0
Router#
Table 1
Cisco VGD 1T3 Voice Gateway Software Configuration Guide
34
describes the significant output fields in the previous example.
Verifying Basic Setup on the Cisco VGD 1T3 Voice Gateway