HP Visualize c100 Service Handbook page 51

Chap3.doc 37 Fri Sep 15 14:07:30 1995
Table 7 Storage Configurations
Disk
Supported
Tray
Devices
Position
1 Floppy Drive
1-inch Low Pro-
file Disk Drive
2 CD-ROM
DDS-Tape
3 1-inch Low Pro-
file Disk Drive
1.6-inch Full
Height Disk
Drive
4 1-inch Low Pro-
file Disk Drive
1.6-inch Full
Height Disk
Drive
All hard disk drives are fast, wide SCSI devices. The CD-
ROM drive and the DDS tape drive are single-ended SCSI
devices. The floppy drive is not a SCSI device.
Table 8 lists the recommended SCSI IDs for internal
storage devices. Figure 8, Figure 9, and Figure 10
show the Fast,Wide Differential SCSI ID settings for
the hard disk drives. Figure 11 and Figure 12 show the
Single-Ended SCSI ID settings for the CD-ROM drive
and the DDS drive. Figure 13 shows the Operation
Mode switches for the DDS drive.
Configuration
FRU Configurations
Conditions
If a CD-ROM drive is
installed, install a 1.6-inch
full height disk drive in this
position.
This is the preferred posi-
tion for a 1.6-inch full
height disk drive.
If a CD-ROM drive is
installed, a 1.6-inch full
height disk drive cannot be
installed in this position.
37