Storage Devices - HP Visualize c100 Service Handbook

Storage Devices

Before removing storage devices, remove the Storage
Tray Assembly from the system unit.
Before removing a hard drive in either of the storage
tray's rear positions, remove the Disk Interconnect
board.
NOTICE: Refer to chapter 3 for supported storage tray
configurations.
Perform the following steps to remove a storage
device from the system unit:
1 Disconnect the power and data cables from the device
NOTICE: If you are removing a floppy drive or a hard disk
drive in the lower front position, you should
disconnect the cables after performing Step 2.
If you are removing a hard disk drive in the lower
front position of the disk tray, you must remove the
lower filler panel before removing the drive.
2 Push in the locking tab on each side of the disk tray and
you are removing.
slide the device out of the storage tray, as shown in
Figure 28.
Field Replaceable Units
FRU Removal and Replacement
97