HP Visualize c100 Service Handbook page 119

2 To install a memory module, close the ejector tabs on
Figure 35 Installing Memory Modules
3 Press firmly and evenly on the memory module to ensure
4 To verify that this installation was successful, display the
each side of the memory connector and line the memory
module up with the guides, as shown in Figure 35. Make
sure that the notched end of the memory module is to the
left, as shown in Figure 35.
that it is fully seated.
current memory information using the Boot Console In-
terface.
For more information on the Boot Console Interface, see
Chapter 9 of this manual.
If only a faulty memory module is replaced, use the pdt
clear command in the service menu of the Boot Console
Interface. Answer y to the prompt
Field Replaceable Units
FRU Removal and Replacement
Continue? (Y/N)
.
105