Ctr (Pc Interface) Board Installation - Oki OKIOFFICE44 Service Manual

CTR (PC interface) Board Installation

(1) Remove Cover-rear.
Remove the Cover-rear by removing the
screw 1.
Install CTR board.
First, install CTR board on to the
connector CN11, CN12 of R44 board,
and then tighten the two screws to the
separation plate.
Push fit the plate-earth (PC I/F)
Note: Insert the tip of a cutter or nipper
between the mold of Cover-Rear
and cut it out.
Installation Procedure
Cover-Rear
Fig. C.2.1
Fig. C.2.2
2 - 70 OKIOFFICE 44 Service Manual, P/N 59276801
Fixing hook
Screw 1
Board-CTR
(PC Interface)
Plate-Earth
(PC I/F)
Cut out
Screw 1