ENGLISH
Digital Still Camera Mode : Basic Image Taking
Taking and Viewing Your First Photo
Taking Still Images
✤ This function works in
(Programme) mode.
1. Insert the Memory Card (see page 84) and connect a
power source (see page 22).
2. Set the Power switch to
Dial to
(Programme).
3. Frame your subject.
I
Frame your subject using the LCD screen or the
viewfinder.
I
Use the Zoom Lever to zoom in or zoom out.
4. Set the focus by pressing the PHOTO button halfway
down.
I
Locate your main subject inside the focus area
indicated by
, then press the PHOTO button
halfway down to focus on your main subject.
I
You can move your Camcorder to the desired framing
after the focus is locked.
I
Depending on lighting conditions, the built-in flash may
works.
5. Press the PHOTO button fully to take the image.
I
The image is taken and saved into the Memory Card
within few seconds.
I
Taking another image within this interval is not possible.
I
The Memory Card icon will blink while saving the
image.
Taking Still Images: EASY.Q Mode
✤ The EASY.Q mode allows a beginner to easily make good
recordings. With one press of the EASY.Q button, the
Camcorder is automatically set to create the best results
under various conditions.
✤ You can set EASY.Q mode in all Camera modes except
(Play) modes. Press the EASY.Q button again to
return to the previous mode.
[ Note ]
The Auto Power Off feature is designed to save the battery power. If there is no
operation for more than 5 minutes, the Camcorder will automatically turn off.
To resume Camcorder operation, press the Start/Stop button once.
98
98
2
(CAMERA) and set the Mode
3
4
(Movie) and
✤
I
I
PHOTO
I
10
2592
I
I
12:00 AM
I
2005.01.01
I
I
✤
✤