Setting The Zero Memory - Samsung VP-D6550 Owner's Instruction Book

ENGLISH
The Camcorder : Basic Recording

Setting the Zero Memory

✤ The Zero Memory function works in both REC and PLAY modes.
✤ You can mark a point on a tape that you want to return to following
playback.
1. Set the Power switch to REC or PLAY.
2. Press the ZERO MEMORY button on the remote
control before the recording or during playback at
the point where you wish to return.
I
The time code is changed to a tape counter that
is set to Zero Memory with the
(Zero Memory indicator).
I
If you want to cancel the Zero Memory function,
press the ZERO MEMORY button again.
3. Finding the zero position.
I
When you have finished playback, fast forward
or rewind the tape in stop mode.
The tape stops automatically when it reaches the
zero position.
I
When you have finished recording, set the
Power switch to PLAY and press the
button. The tape stops automatically when it
reaches the zero position.
4. The tape counter with the
from the display and the tape counter is changed to the time code.
[ Notes ]
I
In the following situations, Zero Memory mode may be canceled
automatically:
- At the end of the section marked with the Zero Memory function.
- When the tape is ejected.
- When you remove the Battery pack or power supply.
I
The Zero Memory may not function correctly where there is a
break between recordings on the tape.
44 44
1
0:00:00
2
(REW)
(Zero Memory indicator) disappears
✤
✤
I
I
I
œ
I
I
I