Cd Player Section - Kenwood XD-980MD Instruction Manual

CD player section

Symptom
A CD is placed in the player but it cannot
be played.
Sound is not produced.
Sound skips.
CD player section (in regard to message display)
Displayed Message
Err** (** indicates a number)
Remote control unit
Symptom
Remote control operation is not possible.
Cause
The disc is placed upside down.
The disc position is displaced.
The disc is extremely dirty.
The disc is scratched.
Dew is condensed on the optics lens.
The disc has not been placed.
The player is not put to the play mode.
The disc is extremely dirty.
The disc is scratched.
The disc is dirty.
The disc is scratched.
The player is subject to vibration.
Meaning
This indicates some trouble. The number
differs according to the trouble contents.
Cause
Batteries are exhausted.
The remote control is too far away from the
system, the controlling angle is deviated or
there is an obstacle in between.
There is no CD or MD set in the component
to be played.
Remedy
Place the disc properly, with the label side
facing upward.
Place the disc properly.
Clean the disc referring to "Disc handling
precautions".
Try another disc.
Refer to "Beware of condensation" and
remove the condensation by evaporation.
Place a disc in the CD player.
Press the 6 key.
Clean the disc referring to "Disc handling
precautions".
Try another disc.
Clean the disc referring to "Disc handling
precautions".
Try another disc.
Install the unit in a place not subject to
vibrations.
Action
Return to normal condition is made by
switching the unit off and then on again.
Remedy
Replace with new batteries.
Operate the unit inside the remote control-
lable range.
Set a CD or MD in the component to be
played.
7 9
In case of difficulty
XD-980MD (En)
5
d
5
5
5
%
%