[Ata] Configuration - AT&T SB67030 Administrator's Manual

[ATA] Configuration

Figure 55. ATA
Configuration
Getting Started
Synapse Administrator's Guide
in the ATA Main menu until Configuration is highlighted, as shown in
Press /
Figure 55, and press
indicated with . You can use this interface or the WebUI to upgrade software. Here are the
configuration settings:
Configuration — Current ATA settings:
Auto IP — Is set automatically.
Static IP — You can change the Static IP only from the ATA. Although the ATA prompts
you through the process, using a static IP address can have serious effects; contact
your installer if Static IP editing is required.
Restore Defaults — Highlight Restore Defaults and press and hold
seconds when prompted to restore the ATA to factory defaults. See
Restore Settings" on page 172
Upgrade Software — Highlight Upgrade Software, and press
is available, you are prompted to press
to display the Configuration menu. The current setting is
before restoring factory defaults.
again to accept the upgrade.
61
for two
"Back Up and
. If new software