[T1] Configure T1 Settings - AT&T SB67030 Administrator's Manual

[T1] Configure T1 Settings

You can modify the settings of your T1 connection.
To configure the T1 settings:
Figure 155. T1 Settings, Part 1
System Configuration
Synapse Administrator's Guide
163
1. Log in as administrator. See
Administrator" on page
2. Click System Settings, then T1 Settings in the
Navigation Menu at left. The screen shown in
Figure 155 appears.
The system assumes that your T1 circuit uses
B8ZS (Bipolar with 8 Zeros Substitution)
Encoding.
The system assumes that your TI circuit uses ESF
(Extended Super Frame), used in conjunction with
B8ZS, for signaling and to control line Framing.
3. Select the Signaling protocol from the drop-
down list. Signaling information is sent with the
data to convey certain connection parameters.
The default is Primary Rate Interface (PRI NI-2),
which is the modern standard for carrying voice
transmissions.
The other choices are Nortel Digital Multiplex
Switch 100 (DMS-100), and Class 5 Electronic
Switching System (5ESS). With these two
protocols, only the caller ID number, not the
caller ID name, is provided to the Desksets.
"Log in as
68.