AT&T SB67030 Administrator's Manual page 260

Symptom
Multi-zone OHP is not
working and the FXS LED
(right of the ATA LCD screen)
for the FXS port that is used
for the OHP equipment is
OFF.
Multi-zone OHP is not
working and the FXS LED
(right of the ATA LCD screen)
for the FXS port that is used
for the OHP equipment is
solid GREEN.
Multi-zone OHP is not
working and the FXS LED
(right of the ATA LCD screen)
for the FXS port that is used
for the OHP equipment is
flashing GREEN.
Troubleshooting
Synapse Administrator's Guide
Probable Cause
No signal is detected.
Inconsistent configuration.
A device other than an OHP
(such as a fax machine) is
connected to the FXS port
and has gone off hook.
Someone has initiated a
page, but the OHP
equipment has not yet
acknowledged the page
request.
Corrective Action
There is no signal when no one is paging.
Verify that your paging equipment is connected to FXS 1
or FXS 2. If not, connect it, and check your OHP
equipment connections.
Verify the WebUI configuration. See
WebUI configuration:" on page
Refer to your OHP product documentation for installation
and configuration instructions.
Verify the WebUI configuration. See
WebUI configuration:" on page
Verify the connection between the FXS port and your OHP
system. See "[ATA] Overhead Paging Overview" on
page 122 for background and for configuration
instructions.
Verify your paging equipment configuration. Check to see
if the OHP system has settings that need to be adjusted
to work with Synapse.
260
ATA OHP
"Verify the Multi-Zone
259.
"Verify the Multi-Zone
259.