Table of Contents
Advertisement
The purpose of this section is to instruct the operator on how to perform a basic scan using the
Touch
Screen, and to provide general operating tips (things you should know).
Things You Should Know
•
The Infinity WF Scanner is designed as a scan-from-center device. This means that at least
some part of the document being scanned must be placed on the center of the scan table
(Figure 6.1)
Top of Scan
Table
Figure 6.1: Scan document placement (center)
•
The Infinity WF has the available option of a Foot Pedal. The Foot Pedal is used by the
operator to issue a scan command instead of using the Touch Screen. Foot Pedals can be
purchased through a BBH Authorized Spare Parts Reseller (ASPR). A complete listing of
ASPRs can be found on the BBH web site at:
The following instructions assume that the scanner has already been properly installed and set
up for use.
To scan a document, perform the following:
1. Power ON the scanner (see
2. Tap the Touch Screen when prompted
completes the
start sequence
more information)
3. Set the scan-to-location (see
4. Position the document to be scanned on the scan table as close to center as possible
(Figure
6.1).
S008459 Rev C
6 How to Scan a Document
Center
Document to be
scanned
From Center
www.bbhscanners.com
1.6.1 Powering
ON/OFF)
(Figure
3.1). After the scanner runs through and
the
Main menu
will be displayed (see
5.1 Scan to
Location)
6 How to Scan a Document
Top of Scanner
3.3 Ready for Use
for
Page
of 117
57
Advertisement
Table of Contents
