Grounding Methods - HP AA988A - Modular Smart Array Storage Controller SCSI User Manual

Place parts on a grounded surface before removing them from their containers.
■
Avoid touching pins, leads, or circuitry.
■
Always be properly grounded when touching a static-sensitive component or
■
assembly (see "Grounding Methods" on page 86).

Grounding Methods

There are several methods for grounding. Use one or more of the following methods
when handling or installing electrostatic-sensitive parts:
Use a wrist strap connected by a ground cord to a grounded workstation or
■
computer chassis. Wrist straps are flexible straps with a minimum of 1 megohm
(±10 percent) resistance in the ground cords. To provide proper ground, wear the
strap snug against the skin.
Use heel straps, toe straps, or boot straps at standing workstations. Wear the
■
straps on both feet when standing on conductive floors or dissipating floor mats.
Use conductive field service tools.
■
Use a portable field service kit with a folding static-dissipating work mat.
■
If you do not have any of the suggested equipment for proper grounding, have an
HP authorized reseller install the part.
Note –
installation, contact your HP authorized reseller.
86 HP StorageWorks 2012sa Modular Smart Array user guide • May 2008
For more information on static electricity, or assistance with product