Power Cords; Japanese Power Cord Notice; Electrostatic Discharge; Preventing Electrostatic Damage - HP AA988A - Modular Smart Array Storage Controller SCSI User Manual

Power Cords

The power cord set must meet the requirements for use in the country where the
product was purchased. If the product is to be used in another country, purchase a
power cord that is approved for use in that country.
The power cord must be rated for the product and for the voltage and current
marked on the product electrical ratings label. The voltage and current rating of the
cord should be greater than the voltage and current rating marked on the product. In
addition, the diameter of the wire must be a minimum of 1.00 mm
the length of the cord must be between 1.8 m (6 ft) and 3.6 m (12 ft). If you have
questions about the type of power cord to use, contact an HP authorized service
provider.
Route power cords so that they will not be walked on and cannot be pinched
Note –
by items placed upon or against them. Pay particular attention to the plug, electrical
outlet, and the point where the cords exit from the product.

Japanese Power Cord Notice

Electrostatic Discharge

To prevent damage to the system, be aware of the precautions you need to follow
when setting up the system or handling parts. A discharge of static electricity from
a finger or other conductor may damage system boards or other static-sensitive
devices. This type of damage may reduce the life expectancy of the device.

Preventing Electrostatic Damage

To prevent electrostatic damage, observe the following precautions:
Avoid hand contact by transporting and storing products in static-safe containers.
■
Keep electrostatic-sensitive parts in their containers until they arrive at static-free
■
workstations.
Appendix B Regulatory Compliance and Safety
2
or 18 AWG, and
85