Installation Checklist - HP AA988A - Modular Smart Array Storage Controller SCSI User Manual

Installation Checklist

Table 2-1 outlines the steps required to install the enclosures and initially configure
the system. To ensure a successful installation, perform the tasks in the order they
are presented.
Table 2-1 Installation Checklist
Step Installation Task
1. Prepare the rack for installation.
2. Assemble the rackmount bracket kit and install the
controller enclosure and optional drive enclosures in
the rack.
3. Attach the ear caps.
4. Connect the enclosures.
5. Connect the power cords.
6. Test the enclosure connections.
7. Obtain IP values.
8. Correct enclosure IDs, if necessary.
9. Install required host software and drivers, including:
• MSA2000 Family MPIO DSM
• MSA2000 Family SES Driver
10. Connect the data hosts.
11. Connect the management host.
12. Perform initial configuration tasks:
• Set management port IP properties on the
controller enclosure
• Verify that controllers and enclosures have the
latest firmware
• Set the date and time on the controller enclosure
• Configure host ports on the controller enclosure
• Create virtual disks and map volumes
• Test the configuration
Where to Find Procedure
"Preparing the Rack" on page 28
"Assembling and Installing the
Rackmount Bracket Kit" on page 28
"Attaching the Ear Caps" on page 32
"Connecting Controller and Drive
Enclosures" on page 33
"Connecting AC Power" on page 36
"Testing the Enclosure Connections" on
page 37
"Obtaining IP Values for Your Storage
System" on page 38
"Correcting Enclosure IDs" on page 38
"Host System Requirements" on page 39
"Connecting Hosts" on page 39
"Connecting Remote Management
Hosts" on page 40
"Configuring a System for the First
Time" on page 41
Chapter 2 Installing and Cabling Enclosures 27