HP AA988A - Modular Smart Array Storage Controller SCSI User Manual page 45

As shown in the following example, network parameters, including the IP address,
gateway address, and subnet mask are displayed for each controller.
Network Parameters Controller A
--------------------------------
IP Address
Gateway
Subnet Mask
MAC Address
Addressing Mode
Network Parameters Controller B
--------------------------------
IP Address
Gateway
Subnet Mask
MAC Address
Addressing Mode
8. In the host computer's command window, type the following command to verify
Ethernet connectivity, first for controller A and then for controller B:
ping IP-address
If you cannot access your system three minutes after changing the IP address,
your network might require you to restart the management controller using the CLI.
When you restart a management controller, communication with it is temporarily
lost until it successfully restarts.
Type the following command to restart the management controller on both
controllers:
restart mc both
9. After you have verified Ethernet connectivity, disconnect the serial cable and exit
the emulator.
: 192.168.0.10
: 192.168.0.1
: 255.255.0.0
: 00:00:FF:D5:01:4D
: Manual
: 192.168.0.11
: 192.168.0.1
: 255.255.0.0
: 00:C0:FF:D5:01:15
: Manual
Chapter 4 Configuring a System for the First Time 45