Connecting Scansnap To Your Pc; Connecting The Ac Adapter - Fujitsu Fi-5110EOX2 - ScanSnap! - Document Scanner Operator's Manual

2.2

Connecting ScanSnap to your PC

Follow the procedure below to connect ScanSnap to your PC.
1. Connect ScanSnap to a power outlet using the AC cable.
2. Connect ScanSnap to your PC using the USB cable.
ATTENTION
The following describes each of the above two procedures.

■ Connecting the AC Adapter

Connect the power cable as shown below.
1. Connect the AC cable to the AC adapter.
ATTENTION
2. Connect the AC adapter to the AC adapter connector on ScanSnap and to a power outlet.
18
•
Be sure to connect the AC cable first before connecting the USB cable.
•
Be sure to install ScanSnap Manager to your PC before connecting ScanSnap to your
PC. (For details about the installation, refer to "Installing ScanSnap" (page 6)).
AC cable
Do not use cables other than the ones supplied with this product.
Use only specified AC cable and AC adapter.
Inlet
AC adapter
Outlet