Connecting The Scansnap To Your Pc; Connecting The Cable - Fujitsu ScanSnap S300 Operator's Manual

2.2

Connecting the ScanSnap to your PC

When the installation of the above programs is complete, connect the ScanSnap to your computer.
Be sure to install the supplied programs, and then restart your computer before
ATTENTION
connecting the ScanSnap to your computer with cables. (For details about the
installation, refer to

■ Connecting the Cable

Connect the ScanSnap to a power supply in either of two ways below:
First, connect to a power supply, and then connect to a personal computer with the USB cable.
Power source
Power outlet
(When always operating
the scanner at the same
regular place where it
can be fed power from a
power outlet)
Personal computer
(When using the
scanner at a place
where it reaches no
power outlet, or when
carrying the scanner
together with your laptop
computer around and
operating at a place
where no power outlet is
available)
CAUTION
"Installing the Supplied Programs" on page
Use the following cable:
Power cable
The Power cable
is a combination of
the AC adapter
and AC cable.
USB bus power
cable
Use only the AC cable and AC adapter (power cable) below:
Otherwise, a failure may be caused.
•
Manufacturer: LEI
•
Model No.: NU13-1072166-I3
ScanSnap S300 Operator's Guide
2.2 Connecting the ScanSnap to your PC
"When connecting with the
Power cable:" (page 16)
"When connecting with the
USB bus power cable:" (page
17)
6).
2
See:
15