Verifying Npv - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Verifying NPV

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
To configure a traffic map, perform this task:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# npv traffic-map
server-interface {fc slot/port | vfc vfc-id}
external-interface fc slot/port
switch (config)#
switch(config)# no npv traffic-map
server-interface {fc slot/port | vfc vfc-id}
external-interface fc slot/port
switch (config)#
The traffic map configuration only takes effect after you reinitialize each of the server interfaces
Note
specified in the map.
Enabling Disruptive Load Balancing
If you configure additional NP uplinks, you can enable the disruptive load-balancing feature to distribute
the server traffic load evenly among all the NP uplinks.
To enable disruptive load balancing, perform this task:
Command
Step 1
switch# configure terminal
switch(config)#
Step 2
switch(config)# npv auto-load-balance
disruptive
switch (config)#
Step 3
switch (config)# no npv auto-load-balance
disruptive
Note Enabling disruptive load balancing may force reinitialization of one or more server interfaces. This
action causes traffic disruption to the attached devices.
Verifying NPV
To display information about NPV, perform the following task:
Command
switch# show npv flogi-table [all]
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
34-8
Chapter 34
Purpose
Enters configuration mode on the NPV.
Configures a mapping between a server
interface (or range of server interfaces) and an
NP uplink interface (or range of NP uplink
interfaces).
Removes the mapping between the specified
server interfaces and NP uplink interfaces.
Purpose
Enters configuration mode on the NPV.
Enables disruptive load balancing on the switch.
Disables disruptive load balancing on the
switch.
Purpose
Displays the NPV configuration.
Configuring N Port Virtualization
OL-16597-01